2001 Ski Doo MXZ 600 ZX Chassis Primary Drive Clutch w Electric Start Rotor

  
2001 Ski Doo MXZ 600 ZX Chassis Primary Drive Clutch w Electric Start Rotor. All parts are inspected and deemed usable unless otherwise noted in description. Parts may require some cleaning and adjustments for proper installation. Engine parts should be properly cleaned and lubricated prior to assembly.

ALL PARTS SHOULD BE INSTALLED BY AN EXPERIENCED MECHANIC - (We will not be held responsible for part failure due to poor installation). We will try to answer fitment questions to the best of our knowledge and resources.

The dictionary defines the word "used" as follows: "Not New, Previously Owned". With that being said, this is a "used" part. I will always do my best to make sure the parts that I sell are in good usable condition.

I test vehicles before I tear them down. I also inspect each part before taking pictures. I also sell new parts but they are much more expensive. Bearings, Bushings, Gaskets, Seals, Clutch Plates, Sprockets, Pistons, Rings, and Brake Pads are all considered "wear parts" and cannot be guaranteed unless specifically stated in the description that they are good. PLEASE LOOK AT EVERY PICTURE CLOSELY. All engine parts have been drained of oil and fluids. However, there may be residual fluid in, on, or around the part(s). YOU or YOUR MECHANIC are solely responsible for making sure the part(s) are properly.

Cleaned, lubricated, and installed by a professional mechanic. We highly suggest using new gaskets and seals for engine reassembly as well as following the "Factory/OEM Service Manual" guidelines for proper assembly procedures and torque values for all fasteners. This and all engine parts that we sell are deemed usable by Factory/OEM standards and have come off a good running engine (UNLESS NOTED IN THE DESCRIPTION OF THE LISTING). All Carburetor/Intake parts have been drained of fuel. YOU or YOUR MECHANIC are solely responsible for making sure the part(s) are properly cleaned, lubricated, and installed by a professional mechanic.

We highly suggest servicing carburetors and throttle bodies following the "Factory/OEM Service Manual" guidelines for proper assembly procedures and torque values for all fasteners. This and all carburetor/intake parts that we sell are deemed usable by Factory/OEM standards and have come off a good running engine (UNLESS NOTED IN THE DESCRIPTION OF THE LISTING). ATTENTION: FAILURE TO FOLLOW THE ABOVE PROCEDURES AND GUIDELINES MAY RESULT IN CATASTROPHIC ENGINE FAILURE - AND/OR PREMATURE ENGINE WEAR. Therefore, Benny's Powerports LLC and its employees will not be held responsible for any and all failures associated with the use of these engine parts.

Such as Fenders, Hoods, Etc. These charges are the buyers responsibility. We will NOT mark values lower or mark as gifts - United States and International Government policies prohibit such actions!

All sales after 30 days are considered final. Electrical items are NON-RETURNABLE for 3 reasons. #1 - People using the part for testing. #2 - People installing them on an incorrect machine.

We will not re-sell anything that we can't assure our customer was in working order when they bought it. Benny's Powersports is a small family owned and operated business. We work very hard to establish and keep a good reputation, and customer service is our #1 priority. We have no interest in short changing anyone in any way at all. With that being said, we are human and do make mistakes.

If you feel you cannot leave 5 stars and good feedback for ANY reason, please give us the opportunity to make it up to you. You are our VALUED customer and we will not take you for granted. Powered by SixBit's eCommerce Solution.